Trouble Shooting
Error Messages |
As soon as an error occurs there will be a long beep-sound. Following errors may have occurred. |
| Paper jam | The stepper motor will stop if there is still paper at LB0 - 20 sec after a folding process has been completed or terminated. How to clear a jam |
| Top Cover is open | This error will be displayed when the machine cover has been opened or not closed properly. After the top cover has been properly closed the folder has to be reset by "Power off - Power on". |
| End stage not ready | The message will be displayed when there is an error on the motor PCB or if the PCB is not supplied with sufficient power. In these cases please contact your service engineer. |
| Light barrier cut xx |
When the folder is switched on, all light barriers are being tested. If one of them is covered (e.g. by paper) the error message "light barrier cut xx" will be displayed. LB0 - paper exit The error message "Light barrier cut 00" is also shown if the fuse F1 on the power supply has blown up. Light Barrier Positions |
| Light barrier defective xx | Light barriers are switched on and off permanently. A self-test procedure checks if all sensor receivers receive no light before the sensors are switched on (xx is number 00-04). If this error occurs button ? (select up) speeds the folding motor up, button? (select down) speeds the folding motor down. The elimination of this error has to be completed by pressing button ? (mod/set). The folder will restart then. |